Practical Application Instruction

The simulator is made in the form of a cylindrical platform with a rotating horizontal surface and a wired remote control. The speed, duration and direction of rotation of the platform are controlled by coach using an external wired remote control. Changing the rotation parameters allows you to gradually increase the load and complicate training with increasing skill. The simulator is used with rotation from an electric drive and with free rotation.

BEFORE STARTING

Attention! After a sharp change (decrease) of the air temperature it is allowed to turn on the device no earlier than three hours later, which is necessary to ensure the evaporation of the resulting condensate. After transportation at negative temperatures, before use, wait at least 6 hours at indoor temperature.

Attention! Every time before the activations of the simulator you must make sure that the platform with an anti-slip coating rotates freely - there are no extraneous sounds in the device, there are no visible mechanical damages, loose and foreign parts inside; nothing prevents the platform from rotating by hand. Otherwise, operation is prohibited, please contact the manufacturer.

Attention! The use of the simulator and training with the simulator may only be performed under the supervision of the responsible person who controls the simulator using the remote control.

Please, read the instructions carefully, if you have any ambiguities, read them again or contact the manufacturer for advice.

The power must be provided for operation with the simulator, usually from the household plug. The power must be supplied with a flexible cable according to the design of the simulator.

Before turning on the power of the simulator, make sure that the simulator is firmly installed on a horizontal, flat and solid surface, then connect the remote control (remote control) to the simulator using the provided connector. Then turn the power on (without loading the platform). Make sure that the display on the remote control is turned on, and the selector changes the displayed parameters (increase / decrease of the set speed, direction of rotation). Turn on rotation by pressing the selector, and then turn off rotation by pressing again. Then re-enable the rotation and check for changes in the rotation speed and direction when the values change and the rotation direction changes.

After successful completion of the checks, you can start using the ONLYWIN simulator with the athlete on its platform. Otherwise, operation is prohibited, please contact the manufacturer.